Recent content by mp333

  1. M

    *** Any body use Permatex 85409 Ultra Rubber Gasket Sealant & Dressing?

    BMW gaskets or any rubber components start breaking down around 60k. Its almost design to fail. I am looking to extend the life of the gasket since the Permatex 85409 conditions the rubber and does not harden.
  2. M

    *** Any body use Permatex 85409 Ultra Rubber Gasket Sealant & Dressing?

    Do you use both? And you are referring to also apply on the outer edge of the oil pan? Here is the gasket I am using.
  3. M

    *** Any body use Permatex 85409 Ultra Rubber Gasket Sealant & Dressing?

    Wondering if any body has any experience using Permatex 85409. Looking to replace Oil pan gasket on a 2011 BMW 328 using Permatex 85409 Ultra Rubber Gasket Sealant & Dressing? It's suppose to condition the rubber and not harden. https://www.permatex.com/products/ga.../?locale=en_us...
  4. M

    The Best Light Fixture Ever!

    Thanks PS. What would you recommend in similar form factor. I like the idea of a strip of light that goes around the car lift for even distribution.
  5. M

    The Best Light Fixture Ever!

    Hello PS. Looking to add 8ft LED lighting in my three car garage. Primarily in the bay with the four post car lift. I am looking at T8 LED 7400w fixtures from Amazon. Each bay is 12Wx11Hx24L. Each bay is separated by 2ft support beam. I am planning to install six 8ft fixture lights against the...
  6. M

    Ryobi 1/2" impact wrench w/ charger and 4.0 battery - only $99

    Same here. Had to go two towns over to get one. One thing I noticed the motor vents on the rear you can see sparks shooting out which is interesting when the trigger is engaged and released....
  7. M

    Cyber Monday Only: Mechanix Material 4X Fastfit $10 Free Shipping

    Got 6 pairs with 10% off. Thanks
  8. M

    ***What should I put under my four post lift legs to prevent rust from wintery mix.

    None that I can see. The wintery mix was never near the post... Good Luck with BP lift.
  9. M

    ***What should I put under my four post lift legs to prevent rust from wintery mix.

    Its been over a year. I have not done anything. I would remove any excess snow off the car and wheel wells and under mainly before pulling the car in. Not much hits the floor. And in the morning if there is any left on the floor I use a 2ft squezy I bought from HD and use that to push water and...
  10. M

    *** Anybody use King KB2407 Electric Heater

    Mounting them lower will not move the hot air above the heater as hot air rises. Mounting closer to the ceiling keeps the hot air circulate.
  11. M

    *** Anybody use King KB2407 Electric Heater

    Not for me. My town has the lowest cost Electricity in the state and my garage is well insulated. They are not associated with any of the big utility companies. Also I dont plan to use it all time and when I do it will be set to 50 to 60 at most to take the chill out.
  12. M

    *** Anybody use King KB2407 Electric Heater

    It is roughly 18x15x11. I am in the Patriots country. East Coast Also I do have a Profusion 7500W Model Number: EH-4604B Heater that I did not install if any body is interested in buying PM me.
  13. M

    *** Anybody use King KB2407 Electric Heater

    I just installed one in my three car garage and have to say i like it so far. The reason I picked was I wanted to a local on/off switch with a Profusion heater and could not find easily. Also to change the temperature I would have climb a ladder since the ceiling is 12ft. If its lower ceiling...
  14. M

    *** 50A Power Inlet box recommendation

    Just as the title says. Looking for a 50A Power Inlet box recommendation to feed power from a generator. Thank you
  15. M

    *** Can SER cable run partially with outer jacket removed where it runs thru PVC?

    Got it. So is there any difference between the THHN and the individual Romex cables?
Top Bottom