Recent content by Mr. Chevrolet

Thanks for the reply, did it have the "Diamond Kote" finish on it? Also, did you have to put pieces in between the joints or just caulking? Did you use the pre-made corners or did you make your own?

What's the consensus on these two siding products? Any experiences good or bad. We built a garage and are building a house this year and looking for a good siding product. We initially were sold on Hardi board but were shown LP Smartside this weekend. We heard a lot of warranty issues with...

Yes, it is a thickened edge.

My slab is going to be 32' x 40'. The club footing is 16" thick x 24" wide. The slab will be 5" thick. I'm going to put 2" rigid foam down first (which follows the club footing) and would like to staple the Pex to that. The question I have is how do you support the Pex that hangs out into the...

I'm going to be building a 32' x 40' garage this spring. The club footing is 16" thick and there is a 12" poured wall on top of that. Has anyone formed and poured this all at the same time? I'd prefer this to pouring the 12" high wall after. Does anyone have any pictures of the forms set up for...

Has anyone put their hot water tank (for in floor heating) on a second floor instead of right at the manifold? I'll have an attic truss in my new garage and thought it would be a good idea to get it off the main floor and put it up there. Any thoughts?

I would be looking for one 16' x 9' and two 10'w x 9' high. I'm interested in the residential insulated type with windows (carriage type?). I'm also thinking of the side mount opener so I have the headroom for a 4 post lift.

Where's the best place to get garage doors over 8' high? I'm in the process of designing a garage and was curious as to what the additional cost would be.