Recent content by mrgm

damn good info. subscribed

I have only owned this tube notcher, never used there customer service before this. the notcher does good

I have that tube notcher and misplaced the degree wheel the last time it was apart. Contacted Baileigh and it will cost $45 :shocking: and some change to get it replaced. Would any of you be able to photo copy, scan or take a nice picture of it with a diameter dimension and send my way. I will...

nice

counter weights with small electric motor. you will have a faux wall to house the rail and end of door, may as well throw some weights in there

I like this thread.

reason for the copper pipe being hot is that it is absorbing the heat from the compressed air and dissipating into your garage. that is why your outdoor ac unit has copper coils, that is why your frig has copper coils, that is why radiators have copper coils. The black pipe is thick and layered...

I may be hitting that next year!!! :thumbup:

Got the 3/4" copper cut, set and up 3hrs + travel time. I did look into the pex.. did not like the pressure rating and price. pex and fittings was a good price on there own....add the two tools for $50 or the multitool for $40 (tool for each size of pex), cheaper to do with copper. went in...

will def look at that at Lowes

I do not want 1/2" black pipe. 1. the pressure lose and head gain. I need a min of 3/4". 2. it rusts and is **** for air pipe- which is why I am removing. (same for galvanized). I need clean air, and clean filters 3. does not dissipate heat very well 4. it is a pain in the *** to install. 5...

should have done a search for "sharkbite" :Toilet: thanks!

really old thread....but how are those shark fitting still doing?

I did note on there site that it says "not for air applications". I just don't see the difference in the water/ air applications. it may be about the same price to do pex with push fittings vs copper blahhhhh!!!!!!

cheaper for me to do copper then the aluminum/ flex lines. comes out to about $100 for all copper. If I ever need to mod, I don't have to order anything. I want to source everything locally