mrhemi426's latest activity

-For carbs I try to use the low strength (222 purple) Loctite, it's made for small diameter fasteners that don't require much torque but...

867-5309?

I have two square post lifts I have been using daily for years. Not bolted down. My shop floor slopes 1" from front to rear of the lift...

If it isnt built like an Advantage or Wildfire with full square tubing uprights, I would bolt it down. One mishap and the C channel...

Metal is the only way to go. It has been a few years since our home was built, but at the time cost of completing the shop in sheet...