Recent content by mrtbig

  1. M

    Natural gas hookup help!

    Sleeved.
  2. M

    Natural gas hookup help!

    The horizontal pipe I put in pvc.
  3. M

    Natural gas hookup help!

    Well, I completed project. Thanks for your input.
  4. M

    Natural gas hookup help!

    Thanks, I should have added going to gas grill. The pool line comes off the meter and has a shutoff as well. I’ve had both off for a couple of months debating how to do this but pool heater or grill really won’t be used a lot, I am in Cypress, Tx outside of Houston. So, would that 1 1/4 tee...
  5. M

    Natural gas hookup help!

    See photo. This is my hookup to my pool, but I want to hook up another line on pipe coming up and put in a on-off cutoff so extra line can be shutoff as well. I will be running along base of slab you see in photo. I need help in telling me what connections and fittings I need to buy to make...
  6. M

    12x12 COVERED PATIO

    Not an option.
  7. M

    12x12 COVERED PATIO

    I am wanting to build 12x12 covered patio on 4 inch slab that is already there. The 12x12 will be with 6x6 posts and beams and ridge with 2x6 rafters with asphalt shingles. My question is? I was advised to cut out holes in slab to pour deeper footers for the posts. I know there is rebar in...
  8. M

    Help covered patio build!

    Can anyone give me a 20x18 plan, how much cost? The roof will be shingled at either 5/12 or 6/12 pitch and open v will be on 18’ end.
  9. M

    Help covered patio build!

    I want to build a 20x18 covered patio and getting confused with different answers. i want to use 6 posts and span the 18’ ends. can I use 6x6 posts, beams and ridge support? Do I need a ridge beam or can I use like a 2x8 ridge board with 2x6 rafters? I don’t want to span the middle 18’ posts...
  10. M

    Add circuits in Garage

    Follow up question - would it hurt if I just cut into the foam insulation enough to drill a hole through top plate so I could just drop the romex? I could always spray a little stuff over it.
  11. M

    Add circuits in Garage

    I would myself but can’t get to top plate because of hard foam insulation. That’s why I asked about hole in ceiling for the emt or pvc. If I wall mounted should come up next to the plate in attic.
  12. M

    Add circuits in Garage

    Hello, I can’t find help on this. My garage is dry walled. I have attic access to load center but not to opposite wall to drop down romex behind drywall. Can I run romex from load center to attic and across attic about 10 feet into either emt or pvc that is wall mounted with hole cut into...
  13. M

    New Garage

    OK, I looked at panel again and on the main breaker on the top there is 200 on the side of the switch. I didn't see it when I took the photo or I would have taken a better one for it.
  14. M

    New Garage

    Re: New Garage - Updated Photo Here is a better photo of the box for you.
  15. M

    New Garage

    I am a newbie, so need help. I want to connect my new workshop/garage which is only about 15 feet from service to my other building. I have attached a photo showing where the service is and new workshop/garage is in background. I also have attached photo of panel in building I want to run out...
Top Bottom