Recent content by mrtwo91

Good point...didn't think about his being a larger lift. I also noticed on Bend-Pak's web site that the Caster Kit is only available for the HD-9 Series lifts. So, I would agree to check the installation manual.

Another ATF here

Nope, not necessary to bolt them down. I have the HD-9 Wide and also bought the Caster Kit for it, makes it easy to move around my shop if needed. Also, check out the RJ-45 Rolling Jack; I love mine...very handy accessory.

I bought the little camo 3000# winch a few years ago with a 20% off and it was sale at the time, think I ended up paying about $25 for it. I welded up a bracket to stradle the crossbar on my HD-9 Lift and use it to winch dead vehicles on and off the lift. The remote comes it real handy, allows...

My kids got me a set of the 3/8 drive for Christmas four or five years ago. I've used them quite extensively, no complaints here.

.....Ouch!

I had thought about that and since I was working by my self, couldn't figure out how I was goimg to stand them up. The hoist, sling and a couple nylon tow straps made the entire assembly process a breeze.

New member here, stumbled onto this site and couldn't resist. Got my HD-9 a little over a year ago and love it. Just ordered a RJ-45 Jack to go with it. I purchased mine from Automotive Service Equipment (asedeals.com) and picked it up at a Conway Trucking Depot, rented a U-Haul truck to pick...