Recent content by MUDFORD

The factory switch is a simple off and on wall switch. I wanted something with momentary to make it easier to line up the set screws for blade adjustment. Not totally needed.

I'm looking for a switch for a gary slitter. 120v single pole. On-off-momentary on. Ordered a few different things but no luck. Local supply house doesn't have anything. edited to add: normal old school looking switch in a single gang metal box.

If you were to get a Goodman 5 ton, Get the square (M) series. It's 2 stages of cooling and heating even in the basic 14 seer. You can have it run a 67% for 10 minutes before it kicks into high.

The furnace portion has the blower. You will need some way to move the air. Most of the HVAC companies build a blower box that only houses the blower and possibly a heat strip.

I'm not sure exactly what it is. It needs a little work, but spins free and makes air. I'd like to know where to start on motor sizing.

How did you mount your Milton 1108? Is there a better option for the same money or less? I'm planning to come into it with copper and run a rubber hose into a hose reel.

I bought one today...junk... pass on this deal.

They came in today. I like them

Me too. I'm going to have to quit coming into this section.

This thread is awesome. Thanks for the deals.

Looks like they are 19.99 now. Free shipping with an order over 35.00 ......nevermind.... I was looking at a different seller

Pulls up as 199 for me..:headscrat

I had made my mind up to make the hour drive after work to get the 44" box. Or possibly the 56" if they were out of the 44". I decided I might better call... They said they don't have any boxes at all... dang..

With your brake, building the plenum will be easy. You'll need to come up with some liner though. It's usually sold in 4'x100' rolls. If you had to buy a whole roll, you would be cheaper to just buy a pre-made plenum. Duct board is easy also, but ideally you would use the special tools for...