Recent content by Mustang67ford

Got the jointer up and running. Sharpened the blades that were in it but have a new set on order. How do I level the tables to be square with the fence? If I make the input table square with the fence, the output is not square and wood ends up not square? Also, put a 4" pulley on the drive...

Thanks, had found that.

Thanks, will look them up

Picked up this jointer today. Not sure if I did good or bad. Screw handle on side is broke and need to get blades. I do have a motor for it. Anybody have any info in it, if its good, and where I can get new blades?

Thanks, Had watched them before. Didnt see anything on the blade moving on the wheels.

Thanks, same to you

Got this fence installed. Turned out good. Added 1" hardwood to each side as opposed to cutting the fence down. Issue I am having now, is my blade changes position on the wheels each time I start it up. Not sure what is going on with that. Sometimes it drifts back like 3/16 or if it didnt...

Just picked up a small craftsman dunlap 103.0209. I think it is 7". Now very big, but seemed unique.

Stumbled upon this today. Its a craftsman dunlap 103.0209 table saw. Included the fence and miter. Its been setting a while it looks and will need to make a portable stand of some sort for it. Will probaby do a teardown to vlean up. Was looking for a larger vintage table saw, and still am...

What model?

Found a jacobs 34-33 chuck I bought. Looks brand new. Says made in usa. Does not say hartford. Box is dated 5/20/03. Is that a good chuck? Hopefully I did good.

Thanks for the info, that helps

Looking to get an older cast iron craftsman table saw. What model shoukd I keep an eye out for? There is a model 113.27610 I seem for sell completely redone on a metal stand for $250. It seemed a little pricy to me but have not researched them much.

Just ordered an old fence and rails off a craftsman 103.0209 table saw. I'm thinking this is the right setup and will just need to cut the fence down some.

Thanks for all the info, I would like to stay with a keyed chuck and am leaning more towards buying new to get my DP back in service but also watching ebay for a new old stock 34 or 6a. Is the jacobs 6279D a good chuck? Would the #34-33 or 33 be better? They are all china though, correct?