Recent content by mytoolsupplies

Hi this is my first post and i am in Australia ,I was a sheep shearer and we used to sharpen our tools on a comb and cutter grinder which was a 2 hp electric motor with a through shaft of 1 inch with a left and right hand threads that held either a 10 or 12 inch flat disc . These discs had a...

No these are a new range ,20 volt

18 & 24 volt are li ion too. These are a new range in 20 volt

As to the 3/4 to 1/2 ,go straight to the 3/8 with a reducing bush or coupling and all will work well. I have a body sander [that is a car body sander for panel work] I run that off my 35 cft compressor and no problem The 14 cft want run it,Both compressors have 20metre 3/8 hoses

The first thing is find out the cubic air requirements for the tools you want to use and then add 30% onto the compressor rating as a compressor with a 10 cubic ft rating pumps 10 cft at 0 pressure, as you will require a set air consumption at say 50 psi the 10cft compressor pumps around 6cft of...

It sounds more like the rings are not sealing Did you hone the cylinder? Check the valves

Hi I am Allan of West Australia and Have e website that sells all types of tools and accessories This being my first post on the garage journal please forgive any mistakes and let me know if I make any, Selling tools I am always searching for any new tools coming onto the market and Dewalt are...