Recent content by nm2

About these bubbles ! I forgot to say you that when I build my floor (11 years) while February, exterior temperature was 5 degree fahrenheit ... A Cie Mixing Concrete added a few purcent of Calcium in Mixer Truck to prevent freeze and Accelerate hardening (usually to Quebec)! This is law to...

Hi Can I use this machine 17inch (300RPM): With this PAD: Plus sand paper 17" diameter GRIT40 to remove paint ? Thanks

Friday, I called my local rental Cie, and said me that our PAD cannot remove paint on concrete floor. Can you give me a link for this PAD, able to remove paint ? Thanks

Hi, My workshop concrete floor has very beautiful with a glossy finish. This concrete was polished while 18 hours when I create my floor (12 years ago)! 6 monts later I painted this floor with an Oil Alkide paint for floor ! Now, I would like remove this paint but I don't want damage my...

Here a video (3minutes) the creation of bubbles 1 hour after the application (no primer), you will notice that many bubbles appears and disappears ! I did this same test with PRIMER (no bubbles appeared), so don't need a video for this :lol_hitti!

For 195 ft2 I used 5.4 liters(mixed) or (1.42 gallon US) or (1.18 gallon Imperial) ! Was OK ? I used a squeegee not notched with roller nylon NOUR 3mm (1/8") with Phenolic Core ! Was OK ? Here video (15 second) demonstrating the consistency of my Epoxy Part-A (no mixed)

Does this item on ebay (20$) doing a JOB as extinguisher ;) to do my living room and my second bedroom ? http://www.ebay.com/itm/121398788397? Thanks

Right, Yesterday I apply on floor (18"x18") a first layer(thin) of epoxy water 50% solid to use as Primer ! This morning I apply a second layer epoxy 100% solid !!! No bubbles additional appeared while curing... so your solution will be a best ! But I have another problem, my roller created...

Does this type of roll replace a normal roll ? Can I use a Sqeege to spread out epoxy and use this roll to equalize or does this roll is for remove bubbles only ??

Does a person tried this type of frame roller double that can accept two standard roll 9 1/2" (total19" side by side) to apply epoxy on floor ? A method economic is using two 9 1/2" roll instead one 18" ! Is it a good idea ? Is it a problem for center line ? What is your comment about this ?

After that I read your message I verified temperature today to know how my SLAB is.... (no sun today as a day that I applied) 1:00 PM = 69 to 70 degre 2:30 PM = 69 to 70 degre 5:00 PM = 69 to 70 degre (edited) 8:30 PM = 69 to 70 degre (next day) (edited) 8:20 AM...

Was near of ceiling ! I will know for my next bedroom ! Thanks Scotty !

I forgot to mention that I have installed a fan in my window to evacuate the odor outside of my house before applying the epoxy ! Does this EXHAUST-FAN would be a cause of my problem ?

Instead apply a Primer, if I grind my floor, and wait one month to apply Epoxy, does a out-gassing will be completed ?

For my second bedroom, can I use a Epoxy paint (oil base) as a primer ? Later, after one day or two, I would apply a 100% solid ? Thanks