no704's latest activity
-
NThey're cutting control joints six days after the pour? I'd push them VERY hard for a solution that you can live with. This is a...
-
Nno704 reacted to Schurkey's post in the thread New? Shop-tool for comfortably torquing lug nuts/ wheel studs while vehicle is on the lift. with
Like.
My concern is that if the vehicle is somewhat unstable on the lift, torquing the lug nuts causes the wheel to jack-up on the support... -
Nno704 replied to the thread Permit approved!.They are coming tomorrow to cut control joints and do some kind of finish? Curious what they have planned.
-
Nno704 replied to the thread Permit approved!.Well they were able to grind most of the ugly off. Still have a couple of bird baths.
-
N-Feel bad for you.
-
NRain should actually have been your friend during finishing. That is terrible finish work. I'm sorry you have experienced this.
-
Nno704 replied to the thread Permit approved!.Yes it does!!
-
Nno704 replied to the thread Permit approved!.Poured Monday morning. Had a 20% chance of rain and unfortunately got it at the worst time. Finish job looks like ****, but they are...
-
-
Nno704 reacted to cpakalolo's post in the thread Looking for small drive screws or rivets with large heads ?? with Like.
Thank you
-
Nno704 replied to the thread Convert 3.5" round workbox to outlet.
-
-
Nno704 replied to the thread Ideas for Outdoor bench and vise setup..Sono tube filled with rebar and concrete?
-
Nno704 replied to the thread Sewer Snake.Glad she was able to get it fixed! I was going to say to get a jet cleaner, pretty cheap on Amazon. Even better if you already have a...
-
Nno704 replied to the thread Need advise on how I should weld this drive shaft..Clamp it down on some big V blocks.
-
Nno704 replied to the thread Permit approved!.Ya, starting planning before covid, another week or 2 will not matter!
-
Nno704 replied to the thread Permit approved!.Pushed off until Monday for a little cooler weather and an earlier truck time.
