Recent content by nomadskidoo

I've got a 6'5" shear Pexto workss for parts complete Iowa

Guys :Thanks for the interest,I'm putting this unit to storage,if needed in the future I'll lhelp anyone needs,thanks !

south bend layth parts= thr 4,spindle 34,screw32 gears,top mount parts free plus shipping 50158 no motor .

Wouldtake $150 youpick it up Iowa

Metal Lathe for parts,no motor,belt.thread 4 spindle 34 screw32 on side name plate to thr 40x spindle 13x sc80.. 60" top wide,looks like 30"-36" some swing,repeat Parts only.I could separate Gears off Table.Must be 500lbs unit all 1 piece Cast Iron.I can load onto my truck to deliver in Iowa...

Needing a Main gear drive 13" dia 14 gage Pexto 1950s unit

I had 1/2 wall done,the installer made 2"x6" boxes out of pine but I'd use the Log home link,alot of work to make from scratch.

Update:I looked at the carry handle,and I can wrap a piece of Metal under the bolt of handle and carry it over top of the trigger handle,not a tuff job.No handles out there,crazy!

Wanted B&D 14" chop saw handle #121735-60 opsolite not available,if you have one I need it!

Mikegt4; I'll try that Thanks !

Thanks again!I'm looking at the 3 phase convertor,good choice.This unit's like a 1948 by seriall#3/48 so finding a motor could be tuff.

Thanks for the input!I'll start looking for a motor,but I've got another 3 phase motor so might think about a convertor also.

Basic volts x amps=watts 240v x15amp=3600watt div by 746 watt per hp=4.825 HP

"Larry":I'm just trying to run a 3hp 3 phase motor,off of a 220 volt 100amp service supply.I 'v e known, about phase converters,.I know were to buy "Phase Converters".Just if anyone has a better idea?It's a long Winter

It's right at 3 HP/1,800rpm I heard about adding a 1 leg of just 400mf capasitor to work(I know I spell words wrong).Thanks!