Recent content by Nuccio

  1. N

    expensive hydraulic cylinders

    I am looking for 30 ton double acting hollow cylinder with 7" of stoke like the EDH-307 Sent from my SM-N986U using Tapatalk
  2. N

    Portable concrete crusher ?

    Where are you located? They make small crushers the problem is you would have to size it very small to run it threw the crusher. Also usually not cost effective unless you have a lot of concrete to crush and a place to use the RCA (recycled concrete aggregate) after your process it. Here in NJ...
  3. N

    Cement Mixer

    A mortar mixer or a concrete mixer? Electric or gas? I have a Mutliquip gas mortar mixer with the poly drum, I have a Imer electric mortar man 120 and an Multquip electric concrete mixer they all are several years old now and stillbworking fine just have to keep them clean. Sent from my...
  4. N

    Quiet gas powered hydraulic pump

    What equipment are you trying to run? Stanley and Atlas copco make hydraulic power packs. Sent from my SM-G955U using Tapatalk
  5. N

    Best way to fix 2x4 to cinderblock wall

    What happened that it did not hold? I like to use hammer driven lead anchors , probably have used several thousand over the years. Just drill 1/4" hole insert anchor drive it with a hammer and it expands to hold the also make on with Phillips head that can be removed also. Sent from my...
  6. N

    Do you use 4 way angle wrenches?

    I use them mostly on heavy equipment have a set of Snapon up to 1 1/4 Sent from my SM-T817V using Tapatalk
  7. N

    Service truck air compressor

    Yes saw the airpac nice unit. My Bobcat 250 only has about 200+ hours and puts out 12,000 peak watts and will run my electric hot water Hosty if needed. Sent from my SM-G955U using Tapatalk
  8. N

    Service truck air compressor

    The normally use a IR composite 3/4 gun on my truck now and I believe it is only 14 or 17 CFM my compressor is putting out and has taken everything that I need off. Either going to get the Champion or the Vmac. Unless I get a 30 gal Champion and split the tank and mount behind the...
  9. N

    Service truck air compressor

    The VMAC is nice unit just a biy pricey Sent from my SM-G955U using Tapatalk
  10. N

    Service truck air compressor

    With the Champion I am looking at the base mount unit with twin 4 gal tanks and Honda motor. They offer in two configurations splash lubes and pressure lubes is there an advantage in my application? Sent from my SM-G955U using Tapatalk
  11. N

    Service truck air compressor

    I already ditched the original twin 4 gal tanks that they do not make any more. Added an external tank and re placed the unloaded valve on the compressor. The frame is covered in rust and it rattles has been on the truck for 11 years uncovered and never shut the fuel off but it starts on...
  12. N

    Service truck air compressor

    Running impact gun and my plasma torch. Sent from my SM-G955U using Tapatalk
  13. N

    Service truck air compressor

    I have a Miller Bobcat Efi already that is going to get moved over. Sent from my SM-G955U using Tapatalk
  14. N

    Service truck air compressor

    I have seen a lot of Mi-T-M pressure washers used on jobsite never a air compressor. Just put in a request to join that group on Facebook thanks Sent from my SM-G955U using Tapatalk
  15. N

    Service truck air compressor

    Yes I get that. Maybe not necessarily farmilar with those models but with the brand. Sent from my SM-G955U using Tapatalk
Top Bottom