Nutria's latest activity
-
NNutria reacted to kngelv's post in the thread Possible Frigidaire By General Motors Air Compressor? with
Like.
Just found this: James -
NNutria reacted to kngelv's post in the thread Possible Frigidaire By General Motors Air Compressor? with Like.
The below compressor was owned by my Grandfather and later my Uncle. I inherited it a few years ago and finally tried it out today. I...
-
NWilliams Superector Set No. E1-12 It came with the correct 11 sockets (Hex and Square) and 4 extra Hex 620 sockets. it also has an...
-
NNutria reacted to freebo86's post in the thread Sears Craftsman Bench Grinder - any worth? with Like.
Think I’m going to pick these up tomorrow - should do the trick for the rubber feet?
-
NNutria reacted to Banjorear's post in the thread 1966 Craftsman 150 drill press. Excellent condition. with Like.
Very good condition 1966 Sears Craftsman 150 drill press. 1/2 hp motor. No damage to deck and have original owner's manuals. No run out...
-
NI like to dress my wheels with a single point diamond. It is faster than multipoint and leaves the grit open so no subsequent operation...
-
NNutria reacted to freebo86's post in the thread Sears Craftsman Bench Grinder - any worth? with Like.
Thanks for the info! The stones don’t use any bushings or spacers, they are exact fit to fit over the arbour, 7/8s. There are two large...
-
NNutria reacted to Toolfreaky's post in the thread Aquired OLD sandpaper rolls - good/bad? with Like.
Ha, seems like a waste any idea the brand? Are people interested in these? Cleaned a few more and found some numbers.
-
NNutria replied to the thread Aquired OLD sandpaper rolls - good/bad?.Just kidding. They don't look-- to me-- like classic Stanleys or products from some other makers of that time. To my eye, they look...
-
NNutria reacted to RoninB4's post in the thread Sears Craftsman Bench Grinder - any worth? with Like.
-The wheels have to fit the arbor/shaft properly. Excessive play allows the wheel to run off center and can account for the vibration...
-
NNutria replied to the thread Aquired OLD sandpaper rolls - good/bad?.Incredible. Use them as dock cleats?
-
NNutria reacted to Toolfreaky's post in the thread Aquired OLD sandpaper rolls - good/bad? with Like.
Threw the bottom ones away and the rest fit in an overflowing 5 gallon bucket. They will sit in the shed to preceed my lifetime. Yup...
-
NNutria reacted to Toolfreaky's post in the thread Aquired OLD sandpaper rolls - good/bad? with Like.
Got this free barrel of old sandpaper rolls. I read humidity can destroy sandpaper. Just wondering what's the take on old sandpaper...
-
NNutria replied to the thread Aquired OLD sandpaper rolls - good/bad?.Kinda nasty, but the price was right. If it works, it works. Is that a pile of small, crusty spokeshaves in the last pic?
-
NNutria reacted to torqueman2002's post in the thread Sears Craftsman Bench Grinder - any worth? with Like.
Just my 2-cents; I would not use stones that came with a used grinder. New ones are not expensive and available from AZ, Grainger, Zoro...