Recent content by nzk

I wanted to share my solution with you guys. My Maxjax has been lifting uneven since install couple years ago, bled and bled with no change. Replaced the slow cylinder under warranty and still uneven. Replaced the fittings, same issue. Hose swap did not help so problem was with the cylinder...

CRG karts! you still race them or just for fun? I just bought a ICC shifter CRG chassis thing is unbelievably fast! steep learning curve for me. whats the plan for the garage floor?

I use ATF as too. I guess I use my lift more than most.

So what fluid is everyone using?

I do it to get the lines out of the way when I work on the car. That's not causing the seals to blow I guarantee u.

No I have never let the car rest on the hydraulics. I usually put safeties and then unhook the hydraulic line.

Yes I've been talking only with their tech dept.

Yes I have, they can't explain it. They say their QC is top notch. Either way I keep getting bum cylinders. I'm only lifting max 4000lb on the 6000lb rated lift. I can't be the only one...

purchased my maxjax almost a year ago and have used it a dozen times or more. im currently on my 3rd cylinder in less than a year. all have failed due to leaking seals. first one went bad, refurb replacement sent, which leaked right away. so third one sent. now the other original cylinder sprung...

Thanks Rb! direct link for those who search in the future.. http://www.mcmaster.com/#nylon-screws/=sjrtqo

What did you guys use to cover the holes in the floor when maxjax is uninstalled? I saw someone post some hex bolts that were flush with the floor but can't find the thread!