Recent content by Old tool guy

Did not know that. So when i see videos of people printing accessories for ceral containers and they include a slot for a humidity gauge … that's not useful?

Are these any good? Reason i ask, when i pull my spools out of the sunlu drier the control panel shows humidity aroud 15%. I put the spool into a ziplock back with a sensor,band when i check bsck 2 hrs later the thingie shows close to 30%. I wait about 2 hours to give the device time to...

Surprised at how small the threads look, and the pitch.

Ok, i went back and read the article, but i didn’t see a reference to the hog ring kit. And what size heat shrink did you buy?

Self-portrait? 😜 I have used the bambu app to convert a couple of photographs to 3d statues and i am amazed at what is produced. It’s like it has access to pictures from several angles.

The manufacturer would not try to sell that unit in florida because they know it doesn’t meet the impact codes, so why can’t they add an alert on the order page based on state or zip code to warn that it doesn’t meet local code?

I remember that article.

How did you crimp/secure the cord ends?

How many diy folks have a proper prybar or more than one kind of hammer.

What did it cost? Is there a name on it?

When i was working as a project manager, at the end of the job we had to rate all the contractors who had worked on it. We rended to use the same ones, especially for it/telecom work, bank equipment, and we had a pool of about 4 gc’s. And only 1 authorized for atm work. But the purchasing...

What’s this tpu you’re talking about? I’m using petg. Dang northsiders …

I could use a spool of Clemson orange. Is that the same as Cali orange? East coast vs west coast.

Of course not. It’s on top of my work table in my “office”, with the ceiling fan and a/c running.

Supports were enabled, they had started to print but not for that portion. I have a sunlu drier. Does the drier temp matter all that much, i thought the goal was a certain MC regardless of how you got there. I thought i had read somewhere that too high of a print temp would cause stringing.