Recent content by oldironowner

Looking very much forward to utilizing it. I have arbor press and 25ton LEMPCO hydraulic press next in que to get rebuilt and rehab’d.

The press also received some new plates for fixturing various items. The plates started life as .750” thick AR500 steel plate. Once I machined them they were then match Blanchard ground. They were machined and made to accept a press fit of four .500” x 1.250” dowel pins. This was done to insure...

Drew up a new mounting end to thread into the machined end of the press screw. Machined a few out of 4140. Now I could get onto making new parts for the press nose. I needed a washer and a new Timken bearing. I machined a new nose as well. All from heat treated 4140. I also added a...

Picked up an old Dake UT-10A screw press recently. Press was mostly complete. It was missing a few things like some parts to the press nose and the thumb screw for the handle to lock it in place. Tore down and sand blasted the press. I had this old Hammond Machinery pin router base that I...

This gear was not correct or well even close. I’ll contact them and see if they would make another and the cost.

I had one made at a gear shop. Off the shelf gear wasn’t available. It wasn’t cheap.

Still working on it. My gear from Mc Master didn’t work. I believe it’s metric possibly. Hoping to finish it soon once I cut the blank.

I guess I don't see your 40% the same way. In fact it is totally incorrect. $70 SHIPPED Priority Mail small flat rate box. That's $10.40 plus tax. Plus driving to USPS. Previously they were $50 + Shipping... So give or take 20% at best. These are 17-4 Stainless. Not 316 Stainless. If you were...

Everything has gone up. Literally everything. Guess you could always buy your own $175,000 CNC and make your own and sell them for nothing if you wanted too.

Looking for any information on these Lempco hydraulic presses. Purchased this one today. Need to purchase a new gauge for it and a seal kit.

Reproduction Craftsman 100/150 quill handles fresh off the CNC in 17-4 H900 Aerospace grade stainless steel. Sold in set of three in either 3/8-16 or 1/2-13 threads. Price is $70 for the set. Includes USPS Priority Mail small flat rate box shipping with tracking to your door...

Thanks. Misspoke there between uploading and adding all the images.

The opposite side of this attachment has a set of pulleys. One side measures .600" and the other measures 3.5". 616314F0-7856-4B33-BCBF-1D3FB9F7ECD1 by J Brauer, on Flickr The small pulley is the driven pulley which is affixed to the grinder arbor. Which is coupled with an o-ring as a belt per...

Yeah only other one I have ever seen. I don’t have the manual myself.

Looking for information on this Craftsman Block Grinder Wet Sharpening & Honing attachment. I purchased one and the small gear that drives the unit has disintegrated into a million pieces upon arrival. I am hoping someone may have one that is in service. I need some dimensions on the gear and...