Recent content by One-Zero

I have this I use with electronics but how do you heat the area enough? When you say big old are you referring to the ones used with heat for lead?

Mac pre knuckle saver. Preferably N1 codes.

Thanks! I’ll give the soldering another shot. I can solder copper fine so I must be ***** footing around when I try it on steel.

Got this partial set from my gramps and looking to complete it. It’s the pre knuckle saver long handles or extra long handles depending on what you read. I’ve recently started using these instead of my snap-on because the beam is not sharp. Anyone have the elusive 10mm CLL210MM? Anyone know if...

Hey guys I have a few of these 1970’s Suzuki TS250 that I’ve restored over the years and I’m re-doing one of them. The the tank has pinholes that I filled with JB weld and dents with body filler back in high school in the 90’s. What’s the BEST way to fix the pinholes? Has anyone tried shrinking...

I just put that into rotation as a mobile hand tool cart. I really like the multiple drawers but I also like the little AMDco mechanic on the older handles because that’s what my gramps had.

Haven’t spent a lot of time on these forums so I’m still getting the hang of it but here’s my remlines/power kraft AMD boxes

Opened a new box and this one is the same but the holes are actually in the mold (would have had to drill the slots) and pointed in the right directions. So your supposed to hang these in the slots but not tighten them down? What keeps them from sliding off?

Ended up buying this old Williams Put gel stripper on the oval but it ate the glue and ruined the Williams sticker Tried it on the big sticker, it worked flawlessly and revealed this snap on eagle printed on chrome.

Wow! Just what I was looking for! Thanks!

I see your 3/8 is a 6 point but is the correct part # sequence for the set just like my 7/16. Was it the common practice for the smaller sizes to be 6 point? I guess I’m going to sell the lot and put it towards building or buying a full matching set.

Instructions only show the chain hangers. There’s the slots but even if you did it blind like a picture frame the slots are in opposite directions with now way to tighten them after. I could drill holes in the face plate and the back to make the slots functional but I haven’t taken one apart to...

Was at OSJL and they had pallets of these 4’ 5000k for $15ea so I bought a case of 3 and put them up in my basement. They are linkable and I’m pretty impressed with the color and diffusion for a $15 light, the only down side is they appear to have surface mounting slots but no holes to utilize...

Ok so I have been compiling all my extra tools and saw that my polished SK wrenches are marked S-K or S•K so I pulled out my C-series and saw that they’re S-K, S-K tools, sk lectrolite, or sk wayne and on top of that some are stamped on the opposite side so if I put them in a rack or hang them...