Recent content by Oregonjam

The next steps are slow. I will need to make the light lens, and reprint the decals that were recreated based on the originals. So it may be awhile until completed but the rest went w very well and it’s back in operating condition minus the light.

Thanks, Yah I've done that but had not come across images of the lens outside of a distant shot or an image from the assembly drawings. Another forum member messaged images to me however so I am am good with the lens. I still need a detail image of the battery cover located in the handle...

Hello, I would like to make a nreplacement lens for an S4 jack. Does anyone have an S4 Jack with the light who can photograph the lens and if possible the battery cover on the handle? I have no idea what they look like to make replacements. Thank you for any assistance. John

The major part of the restoration was completed last week. Blasted and refinished. Just details left. Need to finish the light lens, battery cover, and decals. Then decide if I want to pinstripe or paint the lettering. I recreated the original decals. They were very difficult to make out but I...

Great idea. If you come across the pics send them along. I'll PM you my email. Thank You so much.

That would be awesome. Thank you so much. I have SolidWorks, and Alias available for CAD so whatever you have I’m sure I can make work. Yah casting may be the best approach. If you can send the images as well it would be great. If I cast it I can send you a lens. If you can take photos of the...

Can someone share an image of the battery cover that screws into the end of the handle for the light? Thanks again,

Excellent news! This helps a lot and thank you for sharing the literature. I missed the note about being an early model above. I will take a look through the other posts to see if the Early model pump seals are the same as the other S4 models. Does any one have a light that they could...

That is an awesome Jack you have. Looks great. However, This Jack doesn’t look like the one you shared. The logo is cast into the lifting arm as well as on the sides of the Jack. There is no grease zerc in the center of the pivot for the arm either as shown in your image. Basically I want to...

Thank you. I will see if I can find an image of a complete one to compare. If anyone has those parts and can share images it would be a great help. With dimensions I can fabricate the covers and 3D print the lens. I assume a donor will be impossible to find.

Thanks hiball. What is the cover plate? Where would it go? Thanks

Hello, This Jack looks nothing like the others in seeing. I am looking for assistance with identifying a Jack I will be restoring. The main pump housing says S4-05-1 and S4-40-1 on another casting. There is no serial number plate and does not appear to have ever had a place for one. I...