Recent content by orf

Okay, I'm replaced my last Rough Service bulb and burned my arm for the last time, please give me some good shop work light recommendations. I don't mind retractable corded, as I'm tired of weak rechargeable batteries too. Any LED that actually put out good light? The ones I've played with I...

Looking for garages with 9' door (minimum) and low roof height (about 17' max at peak).

Thanks Marcm157 and Jack D. That's kind of what I'm envisioning. Keep those pictures coming!

Any more ideas?

Yes, I've seen this, but it will not be in the budget.

Can I see some creative garages with big doors and low rooflines? I'm looking at 9' to 14' height doors, but might be limited in my garage peak max height. Anyone?

Heater is still working so-so, but I did find the old limit switch today. The heating guy didn't take it with him. The one installed now is 130-15F and the old one is 120-30F. Would this make a big difference in heat output and slow warm up?

Yeah, I looked for a wiring diagram already, but it doesn't have one. :mad: Can't seem to find anything online either. :headscrat

There are actually 2 limit switches on here. The old one was not 180 (I'm not sure what it was - he took it with him). I'm thinking it has the pair of limit switches for a high (180-40 in this case) and low (and 130-15). I understand how the are measured now by your description, so can I just...

My heating guy replaced a limit switch on my old Janitrol 20K hanging gas heater before winter, but I'm wondering if he put in too cold of one. The new limit switch says F130-15F and the other says L180-40F. Taking nearly 4 hours to get up 55 degrees on a 20 degree day (2 car space) :mad...

Okay. Here's what I did. I found a cheap Speedaire regulator and stuck it immediately after the compressor. Got it dialed to its limit (150), so my filter should be fine. Stuck my regular good regulator after the filter (at 125). I just hope this isn't putting undo stress on my compressor...

Any other opinions? I know the line length isn't ideal, but I hope it works for catching most of the moisture at this short distance. Also, going to put my regulator after the filter even though it is only rated to 150. I'm assuming they mean 150 constant pressure and not holding pressure...

Just got a DeVilbiss CAMAIR QC3 filter that I'm hooking up in my compressor run. First off, the notes say I must have this 25 ft. from the compressor...well, I'm maybe 20 feet. I do have a riser and a water drain before the filter. Think I'll be okay? Also, I didn't realize this thing says...

A-M-A-Z-I-N-G. Kev, are you adopting? :)

Very nice. Where are those 9 drawer red and clear storage bins on the pegboard from? I like 'em.