Recent content by PASSMORE

I have approximately 4800 sq ft of attached garage. our building department's objection was fire related. We overcame that with fire sprinklers and increased thickness of drywall on the lid and walls that abutted living spaces.

Been working on the living area more than the shop. Little by little Mr Welsh, it shall be done.

Getting the old compressor situated now...

Some more. Finishing upstairs too...

Still making headway

I would have to double check but I believe it was 1st gen 3800 which has now been rebadged something else with some upgrades, etc. Door is double sided/insulated, double paned windows, 13Hx20W. I had my reservations about a residential opener lifting 790# of door spanning 260 sq ft, but...

We have several large bodies of water and drought is not an imminent threat on our operations. In the event of a continuous drought, perhaps, but not now.

Not sure I understand your question?

Not too many, but I will be posting update soon on our garage door openers. The 3800's were incorrectly spec'd for this app and failed. Replacing with commercial units from Liftmaster and they are working great!

Thanks man. Been a good truck and works hard. Down for a water pump in pic but normally awfully reliable.

Another perspective

Temp setup for now. Will likely locate wood tools on other side of shop in "storage" or possibly in side garage. They're rarely used outside of construction but handy when needed. Will have 4x8 layout/welding table, lathe, mill, drill press, sanders, chop saw, etc...

Fabrication area of shop. 3p, 220v, and 110 power sources. All air in walls with remote compressor and outlets all over shop.

Thx. Still have a couple of pallets on the ground, but they'll go up on shelves very soon. Bring stuff in slowly from there as we can...

I think so, but in due time as I figure out where things will go. Our use of the shop has changed to allow for more usable space and flexibility (another building going in at another site on ranch for storage and maintenance of ranch vehicles). Will definitely be installing a motorcycle lift in...