paulm12's latest activity

This thread needed a bump. Took me 5 minutes to find it. I guess I could message this person, but I'd rather not get cussed unnecessarily.

Took me four days in the hot sun (including setting up and breaking down staging) but I managed to get some shingles on the new screen...

This week, I refurbished the Emerson Craftsman 113.12110 motor. These are quick, so easy to clean-up and require no special tools.

DP#152 - Part 23, Cleaning and Installing the Feed Handles The feed handles are usually the last parts I install. Dismantling The...

DP#152 - Part 22, Installing the Motor/Mount onto the Head Casting First, I installed the stud all the way into the head casting and...

DP#152 - Part 20, Cleaning and Installing the Motor Pulley Cleaning First, I wire wheeled the key. Next, the pulley was scrubbed...

I made a few mods to my Advantage 4 post lift's ramp setup. I initially set them up as instructed in the video, with the ramps sitting...

Finished up the others:

Finished the refresh of my daughter's bike. Final steps were chain cleaning, derailleur adjustment, rear brake adjustment, test ride...

More coworkers asked for pencil cups and I wanted to make something different, so after a multiple step glue-up, I present the triangle...

Finished up the bench this afternoon and got it dropped off at the powdercoater. My friend was one of the smartest men I have ever...

I was making these pencil cups, and almost finished: ..then I thought of adding some inlay for decoration. Here's how they came out...

So a few weeks back I was trying to make a deal with a local friend to buy his old rubber tire wheel loader, actually, we had been...

Made up a few car grill badges to commemorate Scotland reaching the World Cup after an 28 year absence. I’m under no illusions; if we...

DP#152 - Part 14.3 Assembly I first apply a drop of Super Lube oil in each upper and each lower jaw bore segment. Then, I...