Recent content by pcfithian

Thanks fellas, I’m still looking at options on these. Looks like all are very similar, maybe best to get one with 6,000 lb lift capacity and higher lift capability (4 ring instead of 3?)

You fellas have a recommendation on a pneumatic floor jack? What should I look for when buying one of these? Something like this: https://www.amazon.com/gp/aw/d/B0CHRLWXZZ/?tag=atomicindus08-20

Powerhead swap Evinrude E-TEC 175

Ditto on Instagram

Anyone here have any experience with one of these? https://www.sawinery.net/products/plane-chisel-sharpening-system?srsltid=AfmBOooyyqm-0ZHRCd4Q5OKd9RIhdEPOAEQuQbpdGGGbxEfK4Sy8ltY_

Here’s an option: http://www.quick-trench.com/

Although this isn't in the garage, I found this method to be a good solution to elminate water intrusion into the living space of a below grade bedroom and basement area of our home. Check attached using Schluter Kerdi membrane and SealOnce interior gutter channels from www.waterproof.com

Howdy folks, looking for some help with a project. I built a nice bench seat for the boat out of XPS Foam and mahogany luan. Each side was glassed with 2 oz cloth and epoxy, then varnished with spar urethane. After less than a year of service, the varnish cracked down to the epoxy/cloth layer...

Replacing Predator 212 engine on a vintage Toro 724 snowblower

Yep, highly unlikely another oak tree will fall on it!

Thanks!

Here’s the oak tree fall on the boat that was the reason for the trailer repair. Had to replace the engine and fuel tank as well as repair a 3” hole punched through the deck and bottom.

To tow the boat I built in the same garage. This is a recent picture after significant repairs from the tree damage

Maybe harder. For sure I have more hours in this trailer than the factory

An oak tree fell on the boat and bent/cracked the right side beam. Replacing both beams with longer ones