Recent content by pedroghne

will the pre made separator lids for ok with mdf or should I just go ahead and build a thein separator. also it will be used with the hf dust collector

i seen the thien seperator . the only thing that it doesnt really say is how far the bottom piece should be from the elbow

I just picked up the 2hp dust collector from harbor freight. Iwant to add a pre sseparator. I mostly cut mdf for car audio builds. what would be the best solution to catch the mdf dust before it gets to the filter. would a dust separator did be sufficient thanks

I was just thinking about using an old wrench. the tool chest is a mountain 41" 19 drawer

nice. thanks guys. anymore pics and ideas. also where's the best place to get replacement struts for the lid

i was wondering if anyone had put a handle on there top chest lid. i know for me its a pain when by hands are oily or greasy and i need something out of the top and cant get it open because theres no handle. has anyone installed one and any recommendations on what to use thanks

has anyone heard of or own mountain tool boxes i found a 19 drawer an hour away from me for i believe is a good price but i cant find any info on them

have you ever heard of mountain tool boxes

i was wondering if anyone owns or has seen the us general stainless tool chest. its looks very similar to the recent 44" roller and top chest. i believe its an older model but i found one for i nice price locally . just wanted your opinions it. heres a pic...

I have the ridgid r4512 table saw and I want to extend the fence to the right for wider cuts. I found a place who sells the parts for the saw and they have the same rails that come on the saw. I was thinking of buying the smaller front and back rails with the pieces that connect them together...

that isn't my setup. just an example pick. I need to find a nice drum to use for the separator. if I find a big enough one, can i just use pvc fittings to make the top section of the separator. iv only found 4" kits pre made

same as in this pic but the output circled will go up to the first floor, around 4 ft

the separator has 4" in and out. I'd like to use it and I'm going to upgrade to a Wynn filter. I'm going to mod the dc so it goes straight into the filter section

hey guys. I'm new to the forum. I purchased the hf 2hp dust collector and I'm trying to decide the best place to put it. I'll also be installing a separator with it. my shop is on the first floor but it's not that big, so I was thinking of mounting the dc in the basement and run a 4" line...