Recent content by petie6464

Picked up this lot of Snap on sockets, ratchets and such. Basically for what you would spend at Ruth Chris for a dinner for four.:rocker:

Yeah I can't read any of the writing on it. Seller said it was a "Few Years old" But I thru a socket on it and went to my one ton truck, it rattled the lugs off no problem. I'm sure the Fuel's are better but for the price it works just fine.:rocker:

Been needing and wanting one of these but couldnt belly up for the money. Local buy/sell site this pops up about two miles from my house. With three batteries all good and changer $100

The Evolution Steelsaw2 looks real nice. Never heard of these until now and wow these look nice. About two times what I paid for the Dewalt but will gladly spend another 200 bucks for a tool that works. Thanks for the input all! Ht350 thats me and the wife back in the day~

Well I needed a chop saw today so I ran over to Lowes and picked up a Dewalt D28715 14". Um it's going back. It works, yes but the vice and the adjustment and clamp is really cheap and difficult to move and adjust, going from a 90 degree cut to a 45 degree I spent probably 5 minutes setting it...

Found this little old T-30 Ingersoll Rand Compressor local to me. Was asking $150 so I thru out $120 and they said sold. After getting it home the unloader valve body from the hi-side threads where striped so I turned a new one out of some stainless and it runs like a top. It’s a small 1.5HP...

Thank you!

OK had to look at the pics for a minute. The air coming in from the right and going past the T (thus the air ******) causes a siphon on the line coming in from the bottom of the T right.

This could work, I have access to all the underside of the frame~

I have never heard of that! The tank as I wrote is the frame that holds the Generator and Engine. Its 2 x 4" steel box tubing that connect on all for corners thus making it a complete fuel tank with only the filler neck on one end as access. (Of course there is the pickup and return for the...

Yes I could but would rather keep the unit self contained.

I have a Deutz Generator I am fixing up. The fuel tank is the frame that the generator and Engine are mounted too. This "Frame Tank" has a lot of rust in it. This thing is pretty heavy and there is only one access and that is the fuel fill that is about 1.5" in diameter. So being able to tilt...

Hey guys building a new house and detached 2k sf. garage and looking for concrete floor finish options. I have currently an epoxy floor and although nice it does wear and shows signs of use with chipping and such so I don’t want this again. I use the garage a lot; I build diesel trucks and...

Sold

OK Thanks, again nice job :beer: