Recent content by phoenix5x

Do you have a way of installing a scheader valve in the tank to confirm if the pressure gauge is correct? Or just replace that pressure gauge...There is usually a pressure switch too that determines when the compressor turns off and on could that have gone bad? Sent from my LM-V600 using Tapatalk

Finally got my 62 Lambetta running again..They are So finicky! 3rd or 4th carb finally got it running. Sent from my VS995 using Tapatalk

Its for my 54 chevy truck...its the original frame. Sent from my VS995 using Tapatalk

Picked up a huge arbor press...and continued to work on getting this engine ready to fire. Sent from my VS995 using Tapatalk

Thank you! Sent from my VS995 using Tapatalk

Completed my new welding cart Sent from my VS995 using Tapatalk

Continued work on a new welding cart Sent from my VS995 using Tapatalk

I have a couple apps on my phone I use to test signal strength and overall lte and wifi testing..."wifi analyzer" and "network signal info" are the apps..nothing too serious but they do the job...wifi analyzer tells me if I need to adjust channels if I have to..helps clean up the signal a bit...

Nice..i got 2 more connections to make for the wall plates in the office but dont have the computers in there yet to connect to an so they arent too important..i spent most of the time taking readings and adjusting antennaes so that the wireless propogated through the building properl Sent from...

Ran new cat 6 cable out to the garage and office...setup up the network so now I have highspeed internet out there. Sent from my VS995 using Tapatalk

Each compressor is different but from reading info on mineit needs roughly a minimum of 50 ft before any points of use. Plus my compressor already has an after cooler on it before air goes into the tank. So I used a combo of black pipe and reinforced rubber hydraulic line..but i also put in a...

Been running new air lines. Nothing special just schedule 80 off to 4 separate outlets around the garage. About 250 ft of piping so far. Sent from my VS995 using Tapatalk

Basically just tie the 2 tanks together. Outlet of one tank to the inlet of the other tank. The compressor Will run longer, but your capacity will increase So it should be fewer cycles. Question though, Did you add to the shop so the single tank wont keep up any more? Or might there be a...

Been patching up rust on my 54 chevy truck...almost done fitting this kick panel in. Got the driver side rocker tacked in as well.. Started redrilling some ford axles for chevy bolt pattern too. Sent from my VS995 using Tapatalk

Continued building the new motor for my 54 truck..and when I dropped one of the new pistons that stopped that project pretty quick! so pissed!..got a new one on order...so continued to put signs up on my new office in the garage... Sent from my VS995 using Tapatalk