Recent content by phule

Looking to see if anyone has put a series 2/3 side locker on a First gen 44”. I still have my 44” and it’s in great condition so I can justify buying a new box just to fit the lockers.

Just came back from Home Depot found this Ryobi I lit in clearance. Listed for 229. How do these compare to Harbor Freight Bauer line? I just picked up a Bauer drill to do some around the house stuff during my Newley acquired free time. Never one to pass up a deal. I was looking at buying 2 more...

Are they OE locks or aftermarket. If it's a spline drive you can usually get the keys at parts stores. Sent from my SM-N960U using Tapatalk

Do you have a write up on how you built the shelf? Looks great!! Sent from my SM-N960U using Tapatalk

I believe this is what he was talking about "missing bolts". They appear to thread from the direction we cant see. I do agree this is a little more than weeping. I wouldn't be satisfied on a 20k mile vehicle. Sent from my SM-N960U using Tapatalk

I'm cheap, I use a 14 dollar led shop light from job lot works great. Needs to be plugged in. Sent from my SM-N960U using Tapatalk

My question, what do you expect when entering a harbor freight? I dont live close to one. When I am going to a harbor freight I am looking for a specific item that I have researched to confirm it's worth the price(i.e my 44" gen 1 box). I go in with appropriate coupons printed & my free item...

Had a old beater saab going to the scrap yard. Stripped the good run ber off & through some.used junks on. That thing shook like the wheels were octagon until about 45. Then it was tolerable. My car gets a normal dynamic balance(weights inside & outside edge)truck gets a static (sticky weights...

Most alloy toyota truck wheels balance better using a finger plate. If you have a newer high end machine with the adjustable cones that would be ideal. Sent from my SM-N910P using Tapatalk

Subaru also list a muffler bearing If there was ever a time I wish we could like a post Sent from my SM-N960U using Tapatalk

Rubber grommets. I found some rubber grommets of varying opens that fit the holes. Works great. Sent from my SM-N960U using Tapatalk

R32 & 33 my two favorites. Sent from my SM-N960U using Tapatalk

Looks great!!! Magnetic?vinyl? Sent from my SM-N960U using Tapatalk

When I get down to the shop I'll look into it a little further. You are correct it is a 1/4 hp unit. Come to think of it I'm not even sure if it had the guards or not..lol Sent from my SM-N960U using Tapatalk

Finally after many a craigslist ad!!! My new to me grinder! Came with pedestal. Super smooth! Was amazed at how quiet it was. Purchase price was $40. Did I do good? Sent from my SM-N960U using Tapatalk