Recent content by porkyzilla

I am gonna take it down completely. My plan was to take the nuts off studs cut most of the head off...than hammer down the rest past the pilars. guess im not following you as far as walking them down to keep from sliding.

so long story short my bendpack 2 post A symmetrical XPR-10A has to come down from the shop. I am so poor its not even funny right now. No money for pros or equipment rental. Gonna have guys, Truck and Car trailer. with my engine crane. once the top piece is off, pump is off, cables and...

on non power side I had to loosen cable tension and grind on the lock a little bit to make it not stick. after taking a grinding wheel to the bottom edge and lubed it up more got it working perfectly.

not with the equalizer cables I dont care about 1/4 inch but im tired of trying to figure out the saftey lock issue. one last go around today gonna try a few things if not calling someone out. this isnt my first lift i have put up dont understand why im having so much troubles with this one.

when i called bendpak they said it needs to be exact. next time I am paying a professional installer to come out. I will take a video of it maybe.

Hey guys, I am having troubles making final adjustments on my xpr-10a. the safety locks are sticking on non power side. I have been trying to adjust it and cant seem to get it to work. also the carriage arms dont want to seem to adjust evenly. any tips? I am about 1/4 inch off between the...

xpr-10a-168 pricing and availability please. shipped 95670 Rancho Cordova CA commercial space no fork lift

I decided to go with this one. without the low profile arms. I guess its only a .5" difference. and you loose the 3 stage arms. so ill keep the regular arms. http://www.bendpak.com/car-lifts/two-post-lifts/xpr-10a-168.aspx figuring from bestbuyautoequipment.com

Hey guys, after a very very long struggle im finally getting a commercial warehouse to setup my new auto shop. The concrete is old has some cracks peeling paint and bs so im going to do a new epoxy coating. I was thinking the rustoleum epoxy shield professional with a clear is this a good...

:shocking: Hey guys im new :beer: Im eric