Recent content by preludeguy

Yes, there are also a couple more cheap options I could use if I cut the handle like bwringer suggested. I was just at HF and really like the 62333 in its action, thin profile and non-locking flex head. It looks nice. I took a look at it but the 3/8 ratcheting is quite stiff. Not sure why...

Thanks everyone. There is really a wealth of information in this thread. 3/8 in a 1/4 body is an interesting concept but it seems it would be either 36 teeth in the required form factor, or 72 teeth in a different form factor. I see your point that a slightly thicker or less tooth count should...

Hi, I've been working on a timing belt with tight access and find that I would really like a 3/8" ratchet with the following specs 1. thin profile head (<= 1/2") 2. high teeth count (>= 72) 3. 6"-7" length (short enough to swing in close quarters but longer than a stubby to be able to provide...

Thanks Dave, Monte.

Hello, I'm looking for good quality budget jack stands made in Germany. I found some referenced in this thread: http://www.garagejournal.com/forum/showpost.php?p=3011907&postcount=37 It seems that Hösl Hebetechnik, LenzTools, and possibly RP-Tools all sell the same jack stand. The 3-ton one...