Recent content by proorange

We did the compressor side of a turbo and it's holding up fine.

You can have your own artwork generated to film but it's very expensive. We worked with an AR-15 manufacturer on a proprietary print and they had over 10k stuck into it by the time we received it. It's a 3 day process, we prep the part by sanding and/or a chemical bath if it's metal sans...

Something like this? We can make the basecoat lighter also. We have some carbon fiber patterns that are a little tighter here: http://crc2.net/?page_id=996

That is cool. Wonder how they applied that back then?

Got it, Thank You:thumbup:

Not following your meaning by engine turned but I'm still a little wore out from eating so it could be all me:bounce:

Burris Scope in Reaper Black

We get $110.00 for polymer stocks

Here's a Sendaro Rifle Stock we just did in our "Reaper Woods" print. We will be clearing it tomorrow.