Recent content by pushrod-racing

Thank you for the advise

I may look into this then. I see a lot of negative reviews on here for the heaters northern tool sells. So I’m not sure what to go with.

They said any heater under 100k btu i should be ok, but to try to stick to something 70-85k.

I tried to get my local gas supply company to do this or run me a new meter to my garage and I was told they only supplied one meter to each address and i was only allowed to tie in after the regulator.

my shops an all steel 40x60x16 and is only insulated by the 1/4" double bubble or whatever its called insulation. I use my shop mostly to keep my race car and daily drivers in, but I do often have some lengthy projects and work out there hours at a time. The last 3 years ive been using a very...

My employer just removed a lot of the 6 bulb fixtures to update to led fixtures. I purchased 20 of them for 10.00 each. I had only planned to use 12 in my 40x60x16 but now you have me worried I need more. I do have a 10x20 office/bathroom section although that I will not be hanging them above.

I'm sure it's been asked, how many t5ho fixtures do you have total

Was this cost including the heat system? I love the garage and have gain so many ideas from it. The loft is something I never would have though of, and I am so glad I found it on here. Also what method did you use to mount the stud walls to the cement blocks?

Im sure its been mentioned more than 20 times, but for 369.99 the us general 44" tool chest is def a winner. Double ball bearing slides on the thicker drawers. I own several of these. Im a machinist and actually sold my high end kennedy machinist tool box and replaced it with 3 of these 2 for...