Recent content by RamVet

I have one of the three shelves that has been used and abused over many years. Looks rough but still does a great job. No regrets!

Count me in. Thanks!

Had a PP8 Plus for over 12 years now and am completely satisfied. My controls are located exactly in the same position as Post 20. Put it there to be close to the power supply. It would be wise to consider a bridge jack. Really adds a lot of functionality to the lift. Got this tip from...

Pen turning is addictive however is rewarding and they make great gifts. The options are pretty much limitless, and you can tailor the pen for the person you are making it for. Been making them for probably 12 or so years on a Jet midi lathe with no problem. For sharpening, a variable speed...

Shelby7. Mine was racked from the left side to the right side only. Only needed to pull in a single plane to get the drawers square in the cabinet.

Just went through a very similar problem. Got a 5 drawer Lista off CL that had a similar racking issue to the one on the right in the picture above. Long story short, used a car trailer as a flat surface, strapped the cabinet to the trailer and used ratchet straps to re-rack the cabinet in the...

My bench and router table have very similar butcher block tops made with the same wood. Plenty stout and no need to add additional material to stiffen it up. Put a good finish (I used polyurethane) and you have a top that works well, looks good and will last a long time.

jbrentd - Looks like we have the same lift and I've been moving my ramps all around the garage until seeing your post. What a space saver and nice not having to step around the ramps. As usual, Garage Journal fixing problems in a simple and elegant manner. Thank You Sir.

I have an old Workmate and it is a good product. A few years ago, I picked up a Keter Work Table and liked it so much I picked up another to use together for longer items. The Keter Work Table folds up into a nice small package and stores easier that the Workmate. Either is a good choice...

I believe the metal one is used as a wedge to help remove a conical (Morse taper) chuck from a drill press quill.

I bought one about a year ago and have been l happy with it. Have other Dewalt 20V tools and needed to cut down two Bradford Pear trees. Wanted to trim the upper branches before taking down the rest of the tree to make it more manageable. Worked great for that. Since then, I have used it to...

Turned out nice. Looks stout! Congrats on the score.

I'd like a couple of XL when they become available. THANKS!!!!

Looks like Rockler 4-way equal pressure clamps. Check out the Rockler.com website and search for 4-way equal pressure clamps. Great for edge gluing boards for something like a table top. They have a picture of how to build the boards needed to use them to sandwich the boards.

Ring compressor?