Recent content by Razorback0162

Ha...probably a little late on that. Slab cured about 3 years ago....just getting around to framing in bathroom etc..

Thank You

Hello everyone, Hope to get some advise on a toilet install on my shop. I have read that the toilet flange should sit on top of finished floor. Since I am not installing any flooring the slab IS my finished floor. I have also read that the optimal height for the flange is 1/4" above the floor...

Hello everyone, I live in Central Arkansas and have a 30' x 50' metal building shop. The ceiling has cheat thin sheet insulation and the walls and garage doors have 3/4" styrofoam board insulation. I am looking at a natural gas hanging heater unit..from what I can tell something along the lines...

Been listening to some friends...I think I'm letting them get in my head, but they are making me a little afraid not to use copper wire as the feeder instead of MHF al wire. If I was to go with copper, any suggestions, tips, tricks?

Thank You all...makes sense now ....I will run the ground out of the box and through the wall in conduit as it is a post frame metal building.

That is pretty much what I had in my head.....thanks....I just didn't/don't understand the need for the ground rods at the building when the box is grounded back to the house ground. Assuming NEC is allowing for newer structures these days to have more electronics in them ( I will have a flat...

Yes i was looking at using 2-2-2-4 MHf from Lowes..$1.47 ft. 2" conduit the whole way above and below ground. Yes...I think I typed wrong earlier....100amp at sub for disconnect. The heater is a gas furnace given to me...just need to change the orifice and spring as it was running on propane...

Hello Everyone, I have finally built my new shop 30x62 (30x50 enclosed) and now I'm ready to run power to it. I plan on running from my house panel (200 amp) to a 100amp sub-panel in the shop (150' away). Since Copper is high, I am considering using AL MHF - use2 rh / rhw-2 to run between the...