Recent content by RazorSVT

You may be right if just turning it down for the night, but I’d like to think for 6 days of inactivity at a time it would be saving to keep turned down and cost a lot less to use sparingly. -40 and howling winds outside still play a part no matter how insulated a shop is. However I have not...

Yes that’s pretty cool, that’s why I was thinking maybe it would be a good compliment to my forced air as well. Oh really? So I would have to look at low clearance models? I have the same amount as windows and doors as you and pretty sure the same insualation value. Ya I guess I could test it...

Thanks man, it’s a work in progress. Oh ok right on, as a supplement I was just thinking of getting a 30,000 btu. I have a wifi Tstat and yup have to set it about 2 hrs before I want to work in there. I work 6 and 6 so for 6 days I don’t step foot in there so leave it at 5 degrees so I’m not...

Hey guys, I currently have a 60,000btu natural gas forced air heater which takes a long time to warm up the garage in -40 conditions. I live in northern Alberta, where these are normal winter temperatures. I was wondering if many people use an infrared tube heater as a supplement and if it’s a...

Thanks. My ceiling is 10’ but this doesn’t lift the roof off my car past 8’. No it’s not lowered. When I want to use extensions I lift the car up, set the tires down on racewamps then I put on the 6” extensions. Without any adapters the arms sit pretty low, if you still can’t fit for any...

No doubt!!

45” with no adapter, 48” with 3” adapter and 51” with 6” adapter. It’s nice to be working on a rolling stool instead of standing.

Anything and everything. Dropping the engine, trans, kmember, axles, rear end etc. oil changes. Literally everything besides lifting a truck cab off the frame.

In my house I use a Honeywell WiFi Tstat and would like to get another one for the garage and use the same app to control both. I have a Reznor V3 Core2 Furnace with no C wire. I see I have a external terminal (W2) not being used. Is there I can connect it to the board to make my own C wire? I...

No for the street I run Shelby CS-14 20x11” wheels and MT ETstreet SS in 305/35/20 and Racestar wheels with Hoosier 17” bias ply slicks. Oh nice man. With a better 60’ and a lower DA I could be 9.9x-10.00.

Haha Mustang’s take out crowds GT350’s take out curbs GT500’s take no ****.

Thanks! Yes the anchors that came with it.. google weg-it power drop anchors. Thanks! Thanks man. I use 305/35/20 Mickey Thompson SS for the street and I hook in 2nd. Use 17” Hoosier bias ply slicks for the track.

Actually I use 17” bias ply slicks at the track... High DA of 3800’ and I’ll Have to wait until next spring to get a new personnel best since I did some suspension tweaks to lower my 60’. I just copy and pasted my signature from SVTP forum: 2013 Shelby GT500 - SVTTP, SVTPP, Nav, Recaros...

No I cut the tiles around the posts. That’s why I included the close up pic of the post.

Thanks! Yes cut the tiles to go directly to the concrete, used a fence post leveler and only had to use 2 shims on one post.