Recent content by rbjenterprises

I like that you are standing up for your values. I will have to assume that you are wealthy enough or carry enough insurance to make sure that you will never have to receive any government underwritten health care. Sent from my Nexus 10 using Tapatalk

Look here. http://www.jlconline.com/

Read this: http://www.hardieinstallation.com/best-practices.shtml Find the installation instructions from the shingle company. Come lawsuit time if they did not follow the written instructions don't expect the manufacturer to back their product. I have been doing this stuff for 19 years. Just...

Re: 3 way Switch--How can I get circuit to be "off" when both switches down? You can't.

I used smaller ones as a pressure tank for a onboard compressor on my truck. It fit next a frame rail.

That gap on that style of hinge is normal. Once you stick the silicone bumpers on the non hinge side the door will be parallel to the face frame on the cabinet.

I think that this is the same saw, just yellow not grey. I have a 20 year old one. Like a Timex, takes a lick and keeps on ticking. http://www.lowes.com/ProductDisplay?partNumber=74269-70-DW364K&langId=-1&storeId=10151&productId=1209479&catalogId=10051&cmRelshp=req&rel=nofollow&cId=PDIO1

Do not tie the ground bars together on a sub panel. Code requires that ground and neutral be kept separate after the main panel. If the sub panel is used as a main panel you use a single ground and neutral bar or separate ones with a jumper. If you use a panel as a sub panel then the ground and...

I bought one of the cheap bench top Harbor Freight drill presses. It is nowhere near a precision device however it will drill holes in small metal brackets and car and bike parts. I have gone as big as 3/8" in 3/16" steel plate. One absolute must do modification is to replace the chuck with a...

Try genuinedealz on eBay. That is his eBay site he also has a website. Very good stuff at fair prices.

Brain fart. This is what I was talking about, Makita MAC700 Big Bore 2.0 HP Air Compressor. Starts well on a Honda 2000 watt generator even in the winter.

I have had the makita for 7 years. Quiet, low amps but it is not light. I would buy it again if it was stolen.

Read this about the correct way to wire trailers: http://www.noshockzone.org/rv-electrical-safety-part-iv-%E2%80%93-hot-skin/ If GFCIs are wired correctly then the first one protects all those outlets downstream from it.

Now IS the time to call an electrician. It will be cheaper and less painful for you.

Have you checked the hydraulic fluid level?