Recent content by RedToolBox

I definitely despise the Digital version because the readouts start missing segments and you will eventually end up not being able to read it. OLD SCHOOL chargers are getting harder to get and when they are found the price of them are higher than usual 😒. I believe it is disappointing that we...

I received the correct one 6mm in the mail a while back ordered on eBay. I really received a set with different sizes that had the one I needed. I also received one with a single collet in the package from a different vendor that was the correct one. I placed it into the shaft and put the Nut...

My problem with the YESWELDER MIG-205DS has been solved 👌! A tiny half moon Keyway is supposed to be on the shaft but fell into the bottom of the case while changing my wheel from 0.9 mm to 0.8mm. I'm absolutely sure that if anyone else changes their wheel they need to watch very closely not to...

This is a Settings Chart for you if you have the YESWELDER MIG-205DS.

I have the YESWELDER MIG-205DS. Does anyone know why my wire wheel knob won't stay tight on Yeswelder Mig 205DS? It welds well but I'm spending more time tightening that knob than welding! Please invite friends to join us if you don't know the answer. Any other ideas or comments are welcome...

I have already ordered that because the measurements was the 6mm one. I'll try it when it is received. Thanks

Unfortunately the following message was received by the seller on eBay 😕

I forgot to post the Screen Shot I made when I ordered. I'm posting it here:

I Tool Pants, I ordered the one you linked in eBay and I'm looking forward for it to be delivered. Thanks again 😃

Thank you for the informative response! I'll check it out and of course I'd never blame you and any negative outcome. I just appreciate you being here to respond to my post! Thanks 😊

I ordered the parts in the screen shot that I found on eBay. Later I'll see what fits. I used Calipers and it looks like the 6mm one may fit. Since there's 6 in the package I'll have options. I'll let you know if it works out!

I'm not sure about this 🤔 Hardware Stores these days Cary a limited supply of specific parts for older model tools. Tubing seems a bit softer than materials Collett fittings are made of. I'm still searching for it online but I may have to modify one made for a different model. Thanks for the reply 👍

I have a Black & Decker RP200 Type 1 router. Evidently it's a older tool that many parts are not manufactured or supported. I did a search for the missing 1/4" Collett. I have a nut. I did a online search for it with or without the Nut. On a supplier website it says the part is not available...

I went to my local Auto parts store since the post I made above. They told me the name of the Hand Cleaner I mentioned above. It is "Kresto" A new dispenser comes with each container of the soap for close to $50.00. A bit pricey for me but I can't resist shelling out the bucks for some of this...