Recent content by RegalX

I disagree, a quality oil filter is much more important than an air filter when it comes to the longevity of an engine.

Thanks, grabbed some cabin and air filters for the daily drivers. I'll be sticking to WIX tho for my oil filters

I was looking at the brushless Ryobi oscillating tool

Think the "factory reconditioned" stuff is worth taking the chance?

Too bad these aren't MIP*, would be a lot more useful.

I finally made a bracket to support the filter...

Nicely done, I should add a bracket to mine as well just haven't gotten around to it...

finished making this pneumatic pedal ......

CLE Line The 3 flats are really nice. https://www.amazon.com/dp/B00PFQWUF2/?tag=atomicindus08-20

The filter/moisture trap has an "auto drain" on it. When the compressor shuts off the check valve at the tank inlet closes. The feed line from the pump returns to atmospheric pressure. Once the auto drain on the filter drops below 5psi it opens and any moisture falls out. There is also a drain...

The cooler I am running is a remote trans cooler. https://www.amazon.com/dp/B004XONT3E/?tag=atomicindus08-20 I ran 5/8'' OD soft copper line, flared ends and 1/2''NPT Milton filters and regulator. Long runs of type L copper on the wall would be very expensive and take up a bunch of wall...

I have a DIY aftercooler setup with a filter between the pump and the tank. The auto drain in the filter dumps the moisture every time the compressor shuts off and the check valve closes. On the tank output there is a coalescing filter, regulator, etc. IMO it works excellent and pulls a ton of...

Wilton 1755 powder coated...

My aftercooler setup works impressively well, I haven't gotten a drop of water out of the tank, and just a few dribbles out of the coalescing filter.

1/2" plate, 4"x4" 3/16" wall.