Recent content by regancc

Well, can't have either so I didn't compare - need pavers in my community. But, I suspect all that concrete work would've been pricey.

They are low voltage and direct burial - I used conduit anyhow and soldered all the connections (took a while!!) and then heat shrinked and electrical tape to seal them...then capped them in the pvc as an added protection. I know they are not 100% watertight, and the lights themselves aren't -...

More During...: And...After:

Opted to get new pavers and make the driveway a circular as well...while we had that work outsourced, wife and I installed the lighted pavers, conduit, and wiring ourselves - that was a job! We love how it turned out! Before: During:

Had to paint the door and frame to match!! Love it!! And...finally cleaned up...

Round 2 - and Slatwall...

Decided to go with OmniWall for the pegboard - sturdy and I like the way it looks

Partially oiled...

After getting a $21,000 quote to install cabinets and slatwall in my 3 Car Garage, we decided to do the same thing for a little over 1/3 that cost...saved ourselves like $12k by doing the hard stuff ourselves - we are very pleased with the outcome! Here is our layout and what we were shooting...

Love it! Looks magnificent! Also always wanted a vintage T-Bird like that!! Love that as well.

LED Lights I think these are as close as I can find since I bought these last Jan... Chip

I followed some of your lead and put my compressor upstairs in the unfinished bonus room...so happy I did that. Saves room, cuts down the noise, and just makes it a cleaner and more functional setup. Wife insisted on a handrail going up the stairs into the house...that was easier said than...

Painting is starting to pay off...as the place is slowly coming together (I am ashamed at how long this has really taken me!!! :o ) Soffit lights are up and wired...they really came out great...I am very happy with them! I moved that fridge up on the landing so it is now out of the...

As you can see from the photo immediately above, I had to custom build a frame for around the back door as the builder just put it in and left it with the original door frame sticking out of the drywall about 3 inches...so I cleaned it up and put a frame around it...that was a bit of...