Recent content by Relex

Picked up the blower and grinder to add to the collection last weekend.

I scored this Lawnboy snowblower along the curb a couple months ago. When I came across this it was in great overall shape but it didn't have a key. I took it home, cleaned the carb, disconnected the wires to the ignition and wired up a toggle switch and it started, ran and functioned great...

Got bored over the weekend and saw a post on here somewhere about one of these shelves being built. I ended up building one with some scrap wood I had laying around....I still need one more piece to finish the back.

Thanks for the replies. Since I've become a home owner I've been learning a lot.

I bought a house a few months ago and with winter coming I'm trying to get my place as air tight as I can. As that can be seen in the picture I have a gap between the garage door and the wood it goes up against....what's the best way to get this to seal up?... It's also on both sides.

I'm in need of a long(er) lasting pair of boots for work. I've been at my job for a little over 6 months and I'm on my second pair of boots. The picture below is of my latest pair of Red Wings that are barley two months old. It's a little hard to tell by the picture but the boot showing the...

I picked this new box up on clearance a couple days ago. My plan for it is to put together a box for small engine stuff and keep it on top of my bench... At least until I get a bottom section. Sent from my SCH-I535 using Tapatalk 2

This is the stuff I keep in my truck for break downs/helping my friends work on their stuff. Everything in my box is extras that I threw in there from my main tool box.

Thanks for the input everyone.

Thanks for the reply and now I have a couple more questions. What's the max psi I can put in the tank? I want the pump to kick on sooner than what it's set at now for a couple of my impacts. I adjusted the bottom screw a little and it did kick the pump on sooner but it wanted to go past 150...

Last year I got a Speedaire 60 gal compressor for $250 and up until yesterday I was running a Craftsman regulator/filter until it broke. What is your best bang for your buck regulator/filter? I've done a lot of searching around and really haven't found a whole lot.

Other than this I have a small floor jack in my toolbox along with a bumper jack in my truck toolbox.