Recent content by Rewind97

I’m in!

After looking online it seems about 90K lumens (total)is what is suggested for my size shop. The 8 foot tubes would be twice that. With the 4 footers I’m worried about shadows.

After looking, I think you’re right, 6K might not be right for me, probably drop down to 5K

Looking to replace my (12) 4 foot fluorescent lights with (12) 8 foot, 15,000 lumen LED’s in my 30’ X 40’ shop. Wondering if that is too much light. Should I go for (12) 4 foot 7,500 lumen lights instead? They will be 11’ off the floor. Both sets are 6,000K.

Thank you Ronin!!! A lot of good info there, I appreciate it!!! I'll have to take a closer look at the box and see if I can find any markings on it.

Any way to tell the age of the set?

Thank you for the advice, Ronin.

Thank you!! I knew I could count on the GJ!!

Scored this Workmate 300 and tap and die set for $50. Can anyone give me more info on the tap and die set? I have no idea of manufacturer, other than made in USA.

Welcome to the forum, Jeff from your neighbor to the West. I have family in Huntsville, very nice place. If you haven't been to the Space and Rocket museum, you need to check it out!!!

Welcome from Mississippi!

Iron pins are usually used to mark property corners or maybe where the property turns. It could also be where another property intersects with your property.

Welcome from Mississippi! Good luck on you project!!

Welcome from Mississippi!!!

Welcome from your neighbor to the west, Mississippi!!!