Recent content by Rinspeed

After owning PB Swiss they are all shite.

..... and I would take Klein cutters over Knipex any day of the week.

The company, founded in 1868, was known for manufacturing heavy equipment, including machinery for mining, quarrying, and construction. Tools like these would have been specialized for maintaining their specific machinery. The wrench was made by the Sullivan Machinery Company. The company was...

I'm not a big HF shopper but I did buy the ITC when I bought my Predator 9500. It allowed me to get into the sale early, I was slightly concerned they might sell out. I think it was a $500 off sale. I did renew it a couple months ago because there are some decent sales and some free **** now...

Great advice, we almost lost our entire shop when a high quality heat gun turned itself on.

After you have the part number you might even be able to find the part on Amazon.

I use the Zep spray bottles for WD-40 and Purple Power and they hold up pretty well.

Almost look like farrier's nippers I've seen.

I always just used a die grinder with a cookie wheel.

I don't know specifically for a parts washer but Little Giant makes a high quality pump.

At the shop the welders use the big Stanley dead blow hammers daily for beating on SS weldments. I don't remember a single one coming apart which is pretty amazing considering how hard they are abused.

The few times I needed Snap On warranty service they were awesome to deal with.

He also wants to clean silencers. The mouth guard can be cleaned safely in the same tank with a separate glass jar double boiler setup.

I would suggest a used industrial 5 gal. 40 kHz with a mechanical thermostat for the heat. Branson, Crest, Blackstone and L&R are good ones to look at. I've seen them run around $500 used and new they were $3K or so. Check out Ebay although shipping would fairly high I'm sure.