Recent content by rjm32792

The Valves look the same as my Champion REN-10, you need to measure the diameter of valves. Then go to Pacific Air website to check sizes. Good luck, but do not give up yet.

Hi Jon69RagTop, Thanks I just followed this guys setup on you tube, He had worked out all details and I just did mine like his, and it works GREAT

Hi 52wrench, I saw this youtube and he had done the same setup, so I just followed his information, it is amazing the amount of water I recover before it ever gets into my receiver (tank). And I do use the Automatic Tank Drain HF #68244 with additional manual ball valve to get additional...

Hi AG I really like my Puma PK-6060V, it is very quiet, and I have had it 2 years now and never a problem. I added the aftercooler, because here in central Florida, the air is mostly water and I was having a ton of water out my air tools, even with other water traps. After adding aftercooler...

The Puma pump came with gas flair fittings for exit from pump to inlet of tank and I did flair on new copper tube to oil cooler and used flair to 1/2" NPT on oil cooler inlet. on oulet of oil cooler I used a 1/2" Hose Barb x 1/2" Male Brass Pipe Adapter from SUPPLYHOUSE.com to waterheater hose...

Thanks CNG, also working on OLD Champion pump, my other thread is on it, and it is getting wet sandblasted tomorrow morning, so I had to get the PUMA all installed. more photos coming.

Hey Everyone, check out my PUMA Air Compressor with Aftercooler. The Aftercooler is a B&M 70266 oil cooler with 1/2 NPT connections $100.00 from Summit Racing. The cooler lowers the temp from 220 at top inlet and drops it to 90 at bottom outlet. Then the Air is moved through 1/2 inch flex hose...

Hey redmondjp, I hope anyone that gets an older unknown compressor out there, gives Mike a call Mike Henager PACIFIC AIR COMPRESSORS 3009 NE 172ND PLACE PORTLAND, OR 97230 (503)674-2744 FAX(503)674-2883 [email protected] He LIKES a challenge to help out others to SAVE and rebuild...

It is Official, I have a Champion Two Stroke REN 14 Pump. Just received Manual from Mike Henager at Pacific Air Compressors and it identifies my pump as a REN 14. The specs are internal to pump, Bore 4 5/8 LP and 2 1/2 HP and 3 inch stroke. Pump RPM 510 with 3hp 4 7/3 x 1 1/3 - 2VB 200psi 11 cfm...

New valves are in and FIT !!! so I guess this is a type of R15 pump still looking for an age of it, must be an EARLY model. Any help of OLDER Champion pump users would be most helpful. Thank You.

Here are some additional photos of the valves and tank plate which reads year built 1959 from Tank Inc Franklin Park Illinois, Max WP 198 PSI at 650 f, HEADS 1345 "T ELL 'h. SHELL 1345 SER NO 15514. I just received my NEW valves from Compressor Parts Store Valve Set with gaskets Z-102...

Hi Everyone, Just picked this compressor up from CL for $100.00 and I got it home and started to research it by photos on web and then to here. So I think I have it down to a Champion Two Stage R15 but it does NOT have the centrifugal unloading front and has 2 removable sides on the crankcase...