Recent content by rnscustom

Setup a small work area and notched /drilled the new kitchen drawers for Blum runners . Mounted the runners-and installed the drawers .boy it was nice to be working in the garage again , it’s been buried with cars and parts for years , still pretty full but I got an area cleared . That will be...

Looking at the pics reminded me I lost my Hart hammer and still havnt found it

I was looking at this Jack and would be interested to see where it goes , Richard

Gerber eab , Swiss Army Fieldmaster , pencil , and sharpie . At Christmas all the kids come to me to cut the crazy packaging

Maybe a better way to word it is , if someone has a Millermatic Vintage could you tell me if your machine feed has more torque at higher feed rates than low / can you stop the feed motor on low but not high . I guess I’m trying to find out if the new liner will help because the higher the speed...

Thanks Walkers , that’s in the works . Do you have a vintage or 200 , all about the same I think . Bypassing the liner and gun issues my big question is should I be able to stop the feed wheels by holding the wire from pushing out on lower speeds and not be able to stop it on high . And it’s not...

Sorry , didn’t see your budget , but get the most heat you can for your money ,

You need good heat for those manifolds . I’d buy the Hobart 190 , look them up refurbished on their site . they have them listed in stock . I bought one and been real pleased . They come as new packaged as new

Hi , been a while since I’ve been on here . I just purchased a Miller Vintage . I’m having what I believe is an issue with the wire feed . It seems to stall on the lower speeds but it’s fine up faster . It will rotate on low if the tension is not applied / sometimes it will push a little but...

Bosch blades osl114c carbide blades 10 pack from tools plus on eBay $59.99 . Seems like a good buy . Any thoughts

So I received the 3037 Astro belt sander last night looks good only things I see I don’t like are it doesn’t have a safety on the trigger and no cover over the drive area of the belt , there is a pinch area there with the direction the belt rotates . It works great . What is the best grit for...

Thanks Metaleltr , have one on the way .

Ah , unless the belt doesn’t disengage . Fingers keep flying so do as you like , I never stick my hands in there . Hate snowblowers . Never had one till my son moved out and shoveled his driveway for the time . There was a snowblower in my garage the next day ( “ dad I never realized how hard...

Don’t forget engines have compression strokes , engine off it could still rotate once cleared .keep your hands out regardless if it’s running

Hi , I’m interested in the air belt sander model 3037 . Any feedback on these ?? Thanks , Richard