Recent content by Roadyo

Ok, I found the large weight and installed it but still no luck. However, I'm sure the small ball I had in the kit was larger than the small ball I took out. Now it's stuck in the seat and so far I haven't been able to pull it loose. I thought I might drill an access hole from the back and see...

Thanks for the reply. I don't think I had a larger weight. Just the small ball, small weight, big ball and then the piece that threads in. I did have a hard time getting the small ball in initially. Finally tapped it a little with a small punch to make everything fit. I'll double check...

YA700 won't go up I hope I'm not posting this in the wrong place. I don't understand how this forum works but I'll keep diving in till I learn to swim. I just resealed an old YA700 floor jack I've used for years and the darn thing still won't work. First I ordered a new pump unit but that...

In the event there's a hydraulic jack specialist out there, here's my issue. After putting new seals and such in my YA700 it will now raise up about an inch or so when I pump the handle down, but the jack falls down again as soon as I raise the handle. I'm sure it's a simple fix, but I guess...

Hello all. I've been trying to figure out how to post and introduction for the past 40 minutes, and I hope I'm at least close. I'm Bill, I'm 67, mostly retired auto mechanic in northeast Oklahoma and looking for someone who might be able to help me with a Snap-On YA700 I just resealed but still...