Recent content by RonG

So, is SikaFlex not a topical coat? You replied to the OP saying to put SikaFlex on last (after 4500/8100). I'm confused. :)

I have a similar setup as the OP. Mine is a home shop where I build race cars (full tear downs to rebuilds, welding, engine building, etc). My floor needs some serious protection as I have been putting it off. I know I need to get the old oil/stains off as much as possible beforehand...

It is time that I do something with the flooring in my garage (3-bay, 40x25) and am looking at RaceDeck. I know Jorgen comes online here often, so I am looking for his thoughts, as well as others. I build race cars in the third bay (2-post in-ground lift) so have a few questions: 1 - Can I...

Are you in NH? I am on the seacoast, looking to see who else is around here ... Ron

40x25 (13' ceilings) Challenger 9000 lb 2-post in-ground Wayne-Dalton iDrive openers (opener mounts to wall above doors) Radiant floor heating

Did you ever move to Stratham? Are you still working on your rally car? Running SCCA, rallycross? I did some rallycross and autocross, with some help from my 25x40 3-bay and in-ground lift in Greenland. :)

I had the hole dug before laying the tubing, and then had the cassette (which holds the lift innards) installed. Once all the concrete work was done, the lift innards were installed. One important thing to remember - do not have the garage door wall headers installed (or even that part of the...

When I built the house, I was running SCCA, but have taken the past year off, so not sure what I'm doing next year.

Almost :) I'm in Greenland, which is a bit more southeast. :) I have a 25x40 attached garage that I need to post pics of (3 bay, with 2-post in ground lift, radiant floor, 12' ceilings).

They have a new set of lights out that work much better than the original. My original ones had to be pointed in a particular direction (and there were problems with using 3 openers in the same home - due to some switch labeling issues), but the new ones do not have these problems. Ron

I have three (installed in early 2003) and have had a few problems with them. They were very new at that time, so I had the first version. I have since had two replaced with the 'newer' versions and things have been fine since then. I have the complete W-D setup (iDrive for TorqueMaster, and...

Started looking for a 750Pro, and found out it has been discontinued for the new 750X, which is the newer version and now one chuck does up to 3/4" bits. Found this on coastaltool.com for $115 and amazon.com for $120 (free shipping). MSRP is $198, so these are great deals. Ron