Recent content by RubiconJK01

Was going to go the race ramp route too but my driveway is sloped as well beyond the lip of the garage floor and was told those race ramps need to be fully supported all the way beneath them, so they were out of the question. Where did you source those Composite Fiberglass plates and what they...

I got the 12x12 sizes from that site. If I were to get the next size up, which I originally wanted for a bit more coverage under the base plate, the shipping was ridiculously more since it was way more weight. So I opted to just match the base plate. However in doing so, if I ever wanted to...

Here is some pics...

Yes so the front crossbar and runways will obviously be that much higher based on what you did for adding height to the front two posts, or rear posts if its sloping that direction. Here in new england US, the garages are sloped to help with snow melt to the front of garage. So I raised my...

https://vibrasystems.com/load-bearing-pad.html These are what I used. In the end for raising my lift 2.5 inches I think I paid around 375.00 delivered. These are used in between the concrete and bridge trusses for shifting of weight so as not to crack the concrete structures. I felt this...

Thanks ... I forgot about Uline!

Hi all... I have been doing research for a pre made workbench that is at least 30 inches in depth as I feel the standard 24 inches is too small for my needs. I am interested in only buying a solution rather than a diy project as the time to build it, cost of materials with covid has gone up...

Hi All... I've been following this thread for a while and read it over a few times to help decide on my leveling issues with my 4 post Advantage XLT. I have 3.5" inch difference in my floor between rear and front of lift and was told by the installer and by the mfg that this is just fine...

Hi Guys... New here and have a deposit on the Advantage Lift XLT. Wondering if any of you have the air or manual operated bridge jack and if you could give me the real deal on the max clearance it needs with any of the rubber pads removed obviously for clearance. I am told just under 3 inches...