Recent content by s-one

Thank you Armorpoxy for the info. Will do.

Ahh I see ok, that's very helpful to know. Stunning work Mr. Smith did and nice product you guys provide.

Looks great! Does the armorpoxy grit work (non-slip) as good as the shark grip and is it as soft as the shark grip?

Very nice! How did you broadcast the flakes so evenly?

Thanks OP and gatchel. expensive. May just go with OP's t8 results.

I'm new to all this but is there a comparable LED solution in lumens? I realize price would be high on first purchase. thanks.

Now that's a lot of friggin tool boxes!

Lol! =) off to paint I go!

Awesome! I should have called too. Thanks very much for your help.

Hi all, I have the Home Depot Rustoleum Epoxy which is water based. After reading the instructions it says to use one coat in a 4x4 area and spread the flakes. Many of you have mentioned about using 2 coats but with other brands. How long should I wait before applying the second coat...

Wow all great info, thanks!

Ok will do, thanks.

OK well that make sense. But isn't easier to kick up the edge of the epoxy since its flowing into the a groove?

Hi all, Last couple of days I've been prepping.. geez how tiring that was. So now its finally ready... well just waiting a few days for the water from etch to dry up. OK so the question I now have is I noticed that in your photos many of you don't epoxy all the way to the edge of the garage...

OK, so in my case I have an 18x20 floor where the expansion joints are evenly cut at 9x10 which means I have 4 sections at 9x10 to do. I'm using the water based Rustoleum Epoxy Coat with flakes and Epoxy Premium Clear. If I do the base epoxy and flakes for each 9x10 will I need to use spikes...