Recent content by schor

I needed 3 hands to press out a bushing last week so this is what I did.

Top is broken tap extractor and lower are screw extractors.

Spring is there, bearings are on the spindle. Looks like someone just took the spindle out for some reason. It is missing the quill lock but I can make one of those.

Someone was giving away this Walker-Turner 900 as a parts machine, but it looks like there are all the parts except the motor and pulley.

I decorated the shop tree.

I just buy 3in1 products, wd40 is not worth buying.

Check ebay for a table.

Got a link to Kevins stuff? I think I will go with copper jaws in the end, just need to get around to it. My use of a vise is generally holding some piece I am restoring or I have just finished on the lathe or mill and hard jaws are not what I need.

Thanks very much for that info. Yes I did flip them and will flip them back.

I decided to not put copper jaws on it and am calling it done. Not sure when I will actually use it, but I will one day.

I decided to not put copper jaws on it and am calling it done. Not sure when I will actually use it, but I will one day.

The switch block looks great Matt.

nice job Matt.

I've been working on a wilton bullet for the past little while (well a year now, but not solid). Spent some time on the handle today. Still not sure if I will replace it or not. Started out like this. This is the bad end. So I did some wire where work on it and got it looking like this...

Are all vises salvageable? I think so. Let's turn this... Into this