Recent content by Sharky

I've had the best luck at my local Ace Hardware, they carry Craftsman and honor the warranty, sears around here are horrible with warranty replacements. Sent from my SM-G920P using Tapatalk

10 or 12" just depends on how hard you want to pull. Definitely serrated jaw, I prefer straight, but curved have their place too. Sent from my SM-G920P using Tapatalk

I've got SK impact shallow, metric and SAE. They don't get used a lot but there are times that they are the only ones that fit due to the short overall length. Also the impacts don't flex as much and don't fly off the n7t or bolt as easy as the u-joint style chrome. SK has great product...

Thanks much for the reply! Sent from my SM-T217S using Tapatalk

Edit: this is an older pic, it now has a Torin 20T bottle replacing the 12T in the pic. Sent from my SM-T217S using Tapatalk

I have an Arcan, but use an air over hydraulic bottle jack. Very well built and can use manual or air 20 Ton Air over hydraulic jacks can be had for under 100 if you look around. Sent from my SM-T217S using Tapatalk

Putting a thread together, but want to finish it before I post it. Might have to do an "incomplete resto" until i get the drawers finished Sent from my SM-T217S using Tapatalk

Its a keeper, for a while anyway. Here's how it started: Here's where I'm at now: Just need to finish the last 2 drawers. Sent from my SM-T217S using Tapatalk

Getting closer.... I need 19 1/2" long 1 3/4" high Thanks for the replies! Sent from my SM-T217S using Tapatalk

The slide is actually worn through and the metal is stretched. It is a spot welded on runner. I'd like to find a replacement and cut the old one off then weld on a new one. Sent from my SM-T217S using Tapatalk

Looking for a source for the drawer side runner for a Snap-on KR560 cabinet. I got replacement slides from Snap-on under warranty, but the drawer portion is worn out. The rest of the box has been all refurbished, new ball bearing slide for the bottom drawer is on its way. Just need to fix...

Looking for 6 point mid length in the following sizes: 2 @ 1/2" 1 @ 11/16" 1 @ 10 mm 1 @ 14 mm Will buy or trade, have a bucket of sockets, let me know what you need. Thanks all! Sent from my SM-T217S using Tapatalk

Seeems that some of my impact wrenches are loosing power. I stripped, cleaned and relubed them, now they're better. The only "test" i've come up with is to run on a trailer hitch ball / nut and use a torque wrench to measure the force to loosen or tighten further. Anyone try something...

I think Astro made Mac tools impact wrenches like the AW135 any idea on thw AW160? I need an anvil... thanks in advance! Sent from my SM-T217S using Tapatalk

Looking for imfo on a Mac Tools AW160 3/8" impact wrench. I need an anvil and i cant seem to figure out who may have made it. I know the AW135 was Astro Pneumatic, but cant find anything on the AW160. Thanks in advance for any help! Sent from my SM-T217S using Tapatalk