Recent content by Shelby7

  1. S

    Vidmar cabinet frame bent? Help

    Okay, I got the first one sorted out pretty well Question, how much side to side play should be in the drawer when (let’s say half open)? Is it normal to move around?
  2. S

    Vidmar cabinet frame bent? Help

    Oh ya, this one is roughly 1.5” shorter on the top left to bottom right do I need to lay them down?
  3. S

    Vidmar cabinet frame bent? Help

    Should Standing up? And how was yours twisted?
  4. S

    Vidmar cabinet frame bent? Help

    Does anyone have any advice for how to proceed with fixing these cabinets? Pictures attached #1 has a gap from left to right, #2 looks like it’s twisted “right side is high, left side low What’s best practice for figuring where it’s bent exactly and for bending it back? Thanks
  5. S

    Can anyone identify this?

    Anyone?
  6. S

    Can anyone identify this?

    This was posted locally for sale they are 6ft long and 1” diameter steel rods with the eye end and threaded on the other end Some kind of anchor I take it but what are they used for? had to know and figured you lot were best bet thanks!
  7. S

    Highest quality jewelers vise

    Which of the mini or jewelers vises were considered the highest quality? Anyone have expertise with several of the minis that can comment first hand?
  8. S

    Help with Reed 204 1/2r

    Where can I find the collar screw for this vise? Purchased the reed recently and it didn’t have the screw. What size and thread pitch is it?
  9. S

    Help identifying Old specialty pliers?

    Found these old pliers and don’t see a brand anywhere, I cleaned them up and found “Vigor Germany” and I think it says “P1-53” No brand and not sure what they are used for Anyone familiar?
  10. S

    Baldor grinder problem “assistance please”

    I was using my old baldor 7307 1/2hp and about 10 min into using it, I put a little bit of load on it and it powered down big time? It was still on but running very slow Didn’t know what the deal was, didn’t want to cause further damage so shut it off Anyone have an idea?
  11. S

    Help- old 5” bench grinder maintenance question

    Do I have to push it down for oil to go in? It’s bushings
  12. S

    Help- old 5” bench grinder maintenance question

    I just picked up an old Kmart 5” bench grinder this past weekend made in the USA Anyways, on the back of it, says “oil” on each side (pictures attached” Where exactly do you oil and how do you do it? Best I can tell is to drop some in the middle hole (pic 3) but when I did, it didn’t go down...
  13. S

    High quality wire wheels?

    Do the 3m bristle brushes last very long?
  14. S

    High quality wire wheels?

    Can you give link to an example of what u mean
Top Bottom